Datapath VisionAV-HD User Manual download pdf (Page 6)

Installing the Capture Card

You are likely to need a at blade and /or a cross head screwdriver for the installation of the

VisionAV-HD card; it would be useful to have these to hand before you begin.

• Power down the PC (including peripherals), switch o at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate reconnection

• Remove the PC cover

• Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate

(retain all screws)

If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If

the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is

powered up and the warranty will be void.

• Reconnect all cables to the PC then connect a DVI cable (not supplied) distributing the DVI source

signal to the connector on the VisionAV-HD capture card

• A standard denition signal can be connected to the RCA connector on the VisionAV-HD

• An Audio feed can be connected to the Audio Module via the Audio Breakout Cable

• Power up the PC and commence the software installation

How to Connect Input Sources

The VisionAV-HD card has two DVI-I and one RCA (female) connectors, The DVI-I connectors support DVI,

HDMI, Component and RGB (VGA) inputs using the supplied adapters where required.

A DVI input is connected directly into the DVI-I connector which accepts DVI-D (digital) or DVI-A (analog)

inputs:

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Datapath VisionAV-HD User Manual Page 6